Difference between revisions of "Exclusion Mask"

From MyDewetra World
Jump to: navigation, search
(Created page with " [Home] - [back to GFMS Products] ---- The '''Exclusion Mask''' indicates the pixel locations where the SAR data could not deliver the necessary info...")
(No difference)

Revision as of 09:58, 12 November 2020

[Home] - [back to GFMS Products]


The Exclusion Mask indicates the pixel locations where the SAR data could not deliver the necessary information for a robust flood delineation. It combines static effects leading to

  1. no-sensitivity in flood mapping
  2. water-look-alikes
  3. strong topography
  4. radar shadows

(i) no-sensitivity in flood mapping (ii) water-look-alikes (iii) strong topography (iv) radar shadows.

For its generation, we implement the methods proposed in section 1, following the identified problems of SAR-based flood mapping.
The parameter database stores for all locations on pixel basis the areas excluded by the four effect groups, with the radar shadow layer per local Sentinel-1 orbit configurations (up to six per location). During NRT operation, the relative orbit is determined from the S-1 metadata, and the respective Exclusion Mask layers are subset to the extent of the processed Sentinel-1 scene and form a single binary mask for exclusion areas. The Exclusion Mask layer values are described below.


Figure5.jpg


Note

As no-sensitivity is a problem leading often to an underestimation of floods rather than to overestimation (e.g. in urban areas), the no-sensitivity -masking is only applied to pixels that are classified as non-flooded, whereas pixels classified as flooded are kept un-masked. Any no-data areas from the flood algorithm are forwarded to this layer and added as no-data values.



[Home] - [back to GFMS Products]